CAT Enterprises
     
 

All orders requiring technical work will be shipped in about 7-12 days.

galaxy_logo.gif (6857 bytes) 

DX 959 Closeup View
   Click image for larger view

DX 959 PRO

AM/SSB Mobile CB Radio
PROFESSIONAL VERSION

Download Manual

INCLUDED Upgrades !!
Replace both detector diodes with low noise Schottky diodes increasing receiver sensitivity lowering the noise floor.
Replace noise blanker diodes with low noise Schottky diodes to improve the reduction artificial electrical noise.
Replace receiver 1st stage amplifier IC for more SIGNAL and less static noise for receiving distant stations.
I don't Replace any other audio AF or RF stage components. They don't need to be.
I precisely tune the Receiver IAW The Factory Service manual Chapter 4.1.3 (8 steps).
I precisely tune the Transmitter IAW The Factory Service manual Chapter 4.1.2 (9 steps).
I precisely tune the Synthesizer IAW The Factory Service manual Chapter 4.1.1 (This is the frequency alignment and is 8 steps).
I adjust the final and driver MOSFET gate voltage for proper RF bias.
I AM an actual repair facility so I CAN take your repairs and you don't have to send it to Galaxy. I will warranty for a full 60 days and Galaxy warranty remains intact for 2 years.
This is a NEW Galaxy radio, If you would like it for $40 less we can do the same to a Factory Refurbished unit.
Radio complies all FCC part 95 Requirements
  ** IAW= In Accordance With

 

Features

  • Large, easy-to-read meter with 4 scales:
    1. "S" Meter indicates up to 60 dB over S9
    2. Modulation Percentage Scale for use on AM
    3. Power Scale Calibrated for AM and SSB
    4. SWR Scale
  • Automatic SWR Circuit (no complicated calibration procedure)
  • "Talkback" Circuit with On/Off Switch and Volume Control
  • Variable Power Output Control
  • Roger Beep with On/Off switch and LED Indicator
  • Galaxy Noise Filter for use on weak signals
  • High SWR Alert LED Indicator
  • Two Year Warranty as explained below:
  • Five-digit Frequency Display
  • +/- 1.0 kHz Receive Clarifier
  • Noise Blanker and Automatic Noise Limiter
  • AM, SSB and PA Modes
  • 3-Position Tone Control Switch
  • Green/Red LED Indicator for RX/TX
  • LED Channel Indicator
  • Dimmer Control
  • Receive Gain Control
  • Mic Gain Control

 

Other CUSTOM Models

Galaxy DX-959 PRO-RFX

Galaxy DX-959 SUPER PRO-RFX

 

 

... PROFESSIONAL VERSION
AM/SSB Mobile CB Radio ...

$239.50
$229.50

OUT

... PROFESSIONAL VERSION
AM/SSB Mobile CB Radio
 using a Factory Refurbished radio ...

$219.50
$209.50

Use the DX959 BLUE Radio
for either of the above.
$30.00

 
 
 
 
 
Optional Accessories

Fan Options

 RFX-85 Final. (perform a tune-up to radio to increase power, audio and performance and replace the bipolar transistor final with a completely new final section consisting of even higher power MOSFETs)
AM carrier 15 watts and 75+ watts peak power.
 
 RFX-150 Final. (perform a tune-up to the radio. Increase power, audio and performance and a completely new final section consisting of even higher power MOSFETs) AM carrier 35 watts and 145+ watts peak power and 130+w PEP on SSB. $185

RFX-150 FAN KIT Installed Install FOUR - 30 x 30 x 10mm Black Fans with a switch for on/off combined with the amp on/off switch. $59
 Tune-up and frequency conversion. OPTION #1(Install extra channels with switches in back of radio and tune up radios output) $65

OUT
SX-175 Amplifier Kit (same as the RFX-150 but with large heat sink for maximum cooling) Don't forget to buy an external speaker...your radio wont have one anymore with this installed. $234
 Tune-up and frequency conversion. OPTION #2
(Install extra channels with a Lescomm 120 channel kit and tune-up)
$95
Slider Option
 Clarifier "Slider" conversion.
(Modify the Clarifier to control TX and RX frequency. This mod is an add-on to the two frequency conversion mods listed above and if done separately will cost $35)
$15/
$35

 Install an MD-1 Top Gun Modulator.
(wired behind the radio with optional switch for on/off)
$38
 Install an CP-1 Top Gun Audio Compressor. (on - all the time) $25

 Turner RK-56 Noise Canceling microphone.
(wired for this radio with a 4 pin plug)
$46

 Astatic 636L Noise Canceling microphone.
(wired for this radio with a 4 pin plug)
$29

 Astatic D104-M6b Amplified microphone.
(wired for this radio with a 4 pin plug and a battery installed)
$41
 Install an Echo board. (BACK or SIDE)
(wired internal to the radio with dual controls on the side or back to control speed and echo effects)
$65
 Install an Echo board. (Front)
(with dual controls on the front in the Talkback location. Talkback control is cut free of the clarifier board and moved to the side.)
$80

Sound Byte link

 Install a Noise toy
(wired inside the radio with a switch or pushbutton to trigger any 18 second sound byte you want)
$65

Sound Byte link

 Install a Noise toy as a background theme music
(wired inside the radio with a switch to play any background music at very low volume so you can talk over it.)
$65
 Add a Small External Speaker
(plugs into back of the radio for improved sound)
$12
 Add a Large External Speaker
(plugs into back of the radio for improved sound)
$18

Colors

Install Nitro Knobs with dimmer control integration circuit built so it dims with the factory adjustment. 8 Knob set parts and labor.

$179

 

 


Warranty Information

Specifications

GENERAL:
Channels 40
Frequency Range 26.965 - 27.405 MHz
Emission AM/USB/LSB
Frequency Control Phase-Lock-Loop Synthesizer
Frequency Stability 0.001%
Temperature Range -30oC to +50oC
Input Voltage 13.8V DC
Antenna Impedance 50 Ohms
Speaker Impedance 8 Ohms
Size 7-7/8"(W) x 9-1/4"(D) x 2-1/8"(H)
Weight 6 lb.
TRANSMITTER:
RF Power Output AM 1 - 5W 30+W peak;
USB/LSB 15 - 28W PEP
Frequency Response 300 to 2500 Hz
Frequency Tolerance 0.005%
Spurious Emission Better than -55dB
Unwanted Sideband Better than -55dB
RECEIVER:
Sensitivity for 10dB S+N/N AM: 0.5uV; USB/LSB: 0.25uV
Squelch Sensitivity Less than 0.5uV
Audio Power Output 2W @ 10% distortion
Image Rejection Ratio -65dB
AGC Figure of Merit 100mV for 10dB Change in Audio
Clarifier Range +1.0 KHz

 

The item most overlooked when ordering a custom radio is the microphone.  Your new tuned radio will NOT sound great with a stock mic on it.
 If your CB is more than a tool for work, you NEED to upgrade your microphone.  My personal favorites are the Astatic 636L and RD104E.

 

If you place an order from outside the USA,
 we will calculate your actual shipping and
send you a PayPal payment request.

Reviews

   
954-771-8161 Warranty and Return Policy 954-771-8161

BellsCB Radio, 5051 NE 12th Avenue, Oakland Park, Florida. 33334   (954)771-8161